The AC 001 is an extender available in different lengths (standard is 750 mm). It clips on to the tilt frame, making it longer.

It uses a pair of quick-release brackets and it will boost your load height considerably. Standard AUN 200 ramps will lift motorcycles up to 90cm height. However using this extender, users can lift motorcycles up to 1,3 meters or even higher, if the AC 001 is longer than its standard length of 750mm.

AC 001 is compatible with other accessories such as AC 008 (cargo loader) or AC 006 (snowmobile adapter). It is used by clients with higher than normal trucks, or for clients with adventure trucks etc.

It is also very useful for clients having long exhaust pipes that otherwise risk to scrape the ground during loading and off-loading.

This accessory attaches to the main frame of the ramp. It is used mostly for loading motorcycles with large overhangs into vans. It lets you slide the motorcycle further into the van so that you can close the back doors.

It can be used for both AUN 100 and 200 type ramps and is compatible with all other accessories. Available in different lengths. Standard length is 250mm.

Designed for long bed trucks, the AC 004 tailgate adapter lets you close the tailgate after loading your motorcycle. It clips on to the main frame of the ramp without tools. It lets you slide the motorcycle over the tailgate to load and off-load it.

It is compatible with AC 001, 006, 008. Once installed, the tilt ramp can slide on top of it to clear the tailgate.

Very handy if you want to drive with your tailgate closed.

The AC 005 3-wheel adapter lets you transport 3 wheel scooters like the Piaggio MP3. It simply bolts on to the existing wheel chock. It makes it very easy to load and off-load three wheeled scooters.

​

It takes about 15 minutes to remove the upper part of the standard wheel choke and install the 3-wheel adapter.

Designed for a low approach angle so that users can push a snowmobile on to it. Compatible with other accessories such as AC 001, 003 and 004.

Using the AC 006, clients can easily load and off-load even the larger snowmobiles. It simply bolts on to the existing wheel chock.

It is adjustable in height to clear the wheel wells in pick-up trucks, and also adjustable in width to accommodate most models of snowmobiles.

The AC 008 can be very handy if you want to transport general cargo, but also buggies, jet skis, lawn mowers, pallets, 44 gallon drums etc.

It comes as a chassis where clients can choose what type of floor they want, if any. It can also be used to transport two motorcycles as long as their combined weight does not exceed 550kg.

It is delivered as a kit, and is compatible with AC 001, 003, 004. During loading, the AC 008 sits flat on the ground. It can be converted into a container or a tiny camping unit.

It is being delivered without a floor as clients can easily find a plywood or panel supplier if they need a floor. However a floor is not needed if clients transport a jet ski for example.

Using the AC 012 boltless attach kit one can attach the ramp to vehicles without drilling holes in the cargo bed. You can attach / remove the ramp in a matter of minutes.

From a legal point of view, when the ramp is strapped to a vehicle, and not bolted, it is regarded as “payload” in most countries and therefore exempt of many regulations regarding changes made to a vehicle.

From a practical point of view, users can easily detach the ramp from one vehicle and then attach to another, which makes life easier for many motorcycle owners. It makes it also possible to rent the ramp out to people that need transporting motorcycles for either professional or leisure use.